Bay BayStack 400-ST1 Manuel d'instructions télécharger pdf (Page 39)

2. Remove the cascade cable from the Cascade A In

connector at unit 5.

3. Remove the units (units 3 and 4) and install

replacement units as required.

4. Renumber the order of the units for the new stack

configuration (if desired).

You can renumber the unit numbers as described in

your switch’s User Guide.

Removing/Replacing Nonadjacent Units

To remove/replace nonadjacent units from an operating

stack, complete the following steps (Figure 17):

1. Remove the cascade cable from the Cascade A In

connector at unit 3.

2. Remove the cascade cable from the Cascade A Out

connector at unit 3.

3. Remove the unit (unit 3) and install the

replacement unit as required.

4. Reconnect the cascade cables (removed in steps 1

and 2) to unit 3.

Note:

Remove and replace the units individually to

avoid segmenting the stack configuration.

1 2 ... 34 35 36 37 38 39 40 41 42

Pas de commentaire

Bay BayStack 400-ST1 Manuel d'instructions Page 39