Bay BayStack 400-ST1 Manuel d'instructions télécharger pdf (Page 37)

4. Connect a cascade cable from the Cascade A Out

connector of unit 4 to the Cascade A In connector

of unit 5.

5. Connect a cascade cable from the Cascade A Out

connector of unit 5 to the Cascade A In connector

of unit 6.

6. Reconnect the cascade return cable from unit 1 to

the Cascade A Out connector of unit 6.

7. Renumber the order of the units for the new stack

configuration (if desired).

You can renumber the unit numbers as described in

your switch’s User Guide.

Removing/Replacing Units from the Stack

This section describes how to remove and/or replace units

in an operating stack.

Because the Redundant Cascade Stacking feature allows

signals to loopback at a single point of failure, adjacent

contiguous cabled units can be removed and replaced as a

single unit from the stack.

For more information about the Redundant Cascade

Stacking feature, see “Redundant Cascade Stacking

Feature” on page 16.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Bay BayStack 400-ST1 Manuel d'instructions Page 37