Bay BayStack 400-ST1 Manuel d'instructions télécharger pdf (Page 32)

Assigning a New Base Unit to the Stack

To assign a new base unit to the stack, complete the

following steps:

1. Set the Unit Select switch on the original base unit

to the Off position.

See Figure 11 on page 23 for details about the Unit

Select switch.

2. Set the Unit Select switch on the new base unit to

the Base position.

3. Renumber the Stack.

See your switch’s User Guide for detailed information

on how to renumber the stack configuration.

Note:

Nortel Networks recommends that you always

configure the top unit in the stack as the base unit.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Pas de commentaire

Bay BayStack 400-ST1 Manuel d'instructions Page 32