Bay BayStack 400-ST1 Manuel d'instructions télécharger pdf (Page 36)

2. Remove the cascade cable from the Cascade A In

connector at unit 5.

3. Remove the units (units 3 and 4) and install

replacement units as required.

4. Renumber the order of the units for the new stack

configuration (if desired).

You can renumber the unit numbers as described in

“Setting Up the Stack Configuration” in the Using the

BayStack 450 10/100/1000 Series Switch guide.

Removing/Replacing Nonadjacent Units

To remove/replace nonadjacent units from an operating

stack, complete the following steps (see Figure 15

1. Remove the cascade cable from the Cascade A In

connector at unit 3.

2. Remove the cascade cable from the Cascade A Out

connector at unit 3.

3. Remove the unit (unit 3) and install the

replacement unit as required.

4. Reconnect the cascade cables (removed in Steps 1

and 2) to unit 3.

Note: Remove and replace the units individually

to avoid segmenting the stack configuration.

1 2 ... 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Bay BayStack 400-ST1 Manuel d'instructions Page 36