Bay BayStack 400-ST1 Manuel d'instructions télécharger pdf (Page 28)

Modifying an Existing Stack

Configuration

This section provides examples of how to modify an

existing stack configuration. The examples assume the

stack configuration is operational with connected stations.

Always notify the attached stations that there may be a

temporary disruption of the network services before you

begin the modification.

To maintain the unit numbering within the stack, Bay

Networks recommends that you renumber the entire stack

after any modification involving configuration changes.

See the Using the BayStack 450 10/100/1000 Series

Switch guide for more information about renumbering.

This section includes the following topics:

• Assigning a new base unit to the stack

• Adding units to the stack

• Removing/replacing units from the stack

Note: Renumbering causes the entire stack to be

reset with the current configuration settings. The

Reset can take up to 30 seconds for completion.

Notify the connected stations that there will be a

short disruption of network services before

renumbering the stack.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Pas de commentaire

Bay BayStack 400-ST1 Manuel d'instructions Page 28